REP-TAT-P-3221-02-F30 Installing track rod end
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
Check
- Check the gaiter and the spring circlip for damage.
Result
» Component is cracked or porous.
Measure
- Replace component.
Parts: Component
NOTE:
TECHNICAL INFORMATION:
Keep the connection of the tie rod end to the swivel bearing clean and free from oil and grease.
Keep the connection of the tie rod end to the swivel bearing clean and free from oil and grease.
- Insert track rod end (2) into the swivel bearing.
NOTE:
TECHNICAL INFORMATION:
Self-locking nuts must be replaced and must not be reused.
Self-locking nuts must be replaced and must not be reused.
- Replace nut (1).
Parts: Nut
- Tighten the nut (1), if necessary, counter support the Torx socket.
TIGHTENING TORQUES SPECIFICATION
| Track rod end to swivel bearing | |
| M14 Replace self-locking nut. |
175Nm |
Follow-up work
- Mount the FRONT WHEEL