REP-TAT-P-3221-01-F30 Removing the track rod end

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work

Remove the FRONT WHEEL

NOTE: TECHNICAL INFORMATION:
Perform wheel alignment after installation.

NOTE: RISK OF DAMAGE
Component damage caused by striking tools.
Brute force can result in component damage.
Only use those tools intended for the work.

NOTE: Description is for left component only. Procedure on the right side is identical.

Loosen the nut (1), if necessary, counter-hold the Torx socket.
Remove the track rod end (2) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.