REP-TAT-P-3213-02-F30 Install the electromechanical steering gear

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Insert the electromechanical steering gear into the front axle support.
Replace the screws (2) and nuts.
Parts: Bolts, nuts
Tighten the bolts (2) and nuts.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Electromechanical steering gear to front axle support
M10 Replace screws and nuts.	56Nm

Connect connectors (1) and lock.

Follow-up work

Secure the STEERING SHAFT ON THE ELECTROMECHANICAL STEERING GEAR
Install the LEFT AND RIGHT TRACK ROD END
Install the STEERING ASSEMBLY COVER
Install the FRONT UNDERBODY PROTECTION
Mount the FRONT LEFT AND RIGHT WHEEL
Connect the BATTERY EARTH LEAD
Install the RIGHT LUGGAGE COMPARTMENT TRIM PANEL
Refer to ENCODE/PROGRAM CONTROL UNIT(S)