REP-TAT-P-3213-01-F30 Remove the electromechanical steering gear

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Preliminary work

Prepare fault memory printout
Remove the RIGHT LUGGAGE COMPARTMENT TRIM PANEL
Disconnect the BATTERY EARTH LEAD
Remove the FRONT LEFT AND RIGHT WHEEL
Remove the FRONT UNDERBODY PROTECTION
Remove the COVER OF THE STEERING ASSEMBLY
Remove the LEFT AND RIGHT TRACK ROD END
Release the STEERING SHAFT ON THE ELECTROMECHANICAL STEERING GEAR

NOTE: TECHNICAL INFORMATION:
After installation, the end stops must be taught in.
Also, perform wheel alignment after installation.

Unlock and disconnect plug connections (1).
Loosen and remove the screws (2).
Carefully remove the electromechanical steering gear towards the front.

Courtesy of BMW OF NORTH AMERICA, INC.

Check

Check plug connection for moisture and corrosion.
Check the access line for damage.

Result

» Plug connection is moist or corroded.

The insulation of the line is damaged.

Measure

If the insulation of the access line is damaged: Partially replace the access line.
If the insulation of the access line is not damaged: Replace the contacts or the connector housing.