24 40 Torque converter
WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
24 40 TORQUE CONVERTER - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Torque converter to flywheel | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50Z/GA8HP70Z GA8HP75Z | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
56 Nm |
| GA6HP26Z/GA8HP75Z/GA8HP90Z/(AWD) | M10 10.9 | Observe tightening sequence. Refer to repair instructions! For additional information see the following service information, AUTOMATIC TRANSMISSION (GA8HP50Z) Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | |
| F30/F31/F32/F33/F35 N20 GA8HP45Z | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | |
| 2AZ Electrical machine to flywheel | GA8P70H | M10 | Replace hexagon nuts. (Remove adhesive residue from thread, if applicable) |
56 Nm |