12 14 524 Replacing pulse sensor on exhaust camshaft (B48)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)!

Necessary preliminary tasks:

Remove the ACOUSTIC COVER

Removal:

Unlock and disconnect plugs (1).

Release screw (2).

Remove pulse generator (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation for installation:

Check gaskets (1).

Replace damaged gasket (1).

Parts: Gaskets.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install pulse sensor (3).

Tighten screw (2).

Tightening torque, refer to: 13 62 1AZ .

Attach and lock connector (1).

Connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install the ACOUSTIC COVER .