24 00 060 Installing exchange transmission (GA8HP50Z)

WARNING: This page is about a different car, the 2018 BMW 330i and 2017 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.

Attention!

Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
Wear protective gloves.
Ensure adequate ventilation.

Drain automatic transmission fluid at oil drain plug.

Tightening torque 24 11 2AZ .

Attention!

After completion of repair work, program control transmission control unit.

Recycling:

Catch and dispose of escaping transmission oil.

Observe country-specific waste disposal regulations.

Attention!

Before installing replacement TRANSMISSION, ALWAYS FLUSH TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
After completion of repair work, check TRANSMISSION OIL LEVEL .
Use only APPROVED TRANSMISSION OIL .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Exchange transmissions come filled with oil

Necessary preliminary tasks:

Remove the AUTOMATIC TRANSMISSION .

Parts: Replace clamp in the sound insulation.

Courtesy of BMW OF NORTH AMERICA, INC.

Remount ground cable (1).

Remount sound insulation (2).

Remount transportation retainer.

Remount all cable clips.

Remount all seal plugs.

Remount protective cap on output shaft.

Attention!

After removing transportation retainer, secure torque converter against slipping out.

Transmission identification:

Refer BMW Group Parts
On type plate