22 11 011 Replacing left engine mount
WARNING: This page is about a different car, the 2018 BMW 340i and 2017 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Secure ENGINE IN INSTALLATION POSITION .
- Remove FRONT UNDERBODY PROTECTION .
Removal:
Loosen screws (1).
Remove engine mount (2).
Installation:
Installation note:
Rubber part (1) of engine mount must point to center of vehicle.
Install engine mount (2).
Tighten down screws (1).
Tightening torque 22 11 1AZ .
Required follow-up work:
- Remove FASTENING .
- Install front FRONT UNDERBODY PROTECTION .