REP-TAT-P-1353-25 Reset ultra-small quantity adaptation
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
- Connect the diagnostic system and reset the minimum quantity adaptation:
Read out vehicle data
Identification with vehicle test
Start vehicle test
Vehicle handling
Service functions
Drive
Engine electronics
Reset adaptation values
Fuel system adaptation values
Continue service function