REP-TAT-P-1353-02 Install high pressure pump
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in and install high pressure pump (2).
- Replace the bolts (arrows).
Parts : screw
- Position the screws (arrows) of the high-pressure pump (2) and tighten alternating
in 90°
-steps.
Compliance with this specification is imperative to make sure that the piston will not break due to twisting.
TIGHTENING TORQUES SPECIFICATIONHigh pressure pump to cylinder head cover M6X25 Replace screws.
Tightening torque12 Nm - Connect and lock the connector (1).
The connector (1) must engage audibly.