LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> 340i xDrive Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Fuel System - Repair (F30, 6-CYL RWD)) >> 13 51 Injection Pump, Regulating Parts, Mixture Control >> 13 51 017 Removing and installing high pressure pump >> REP-TAT-P-1353-01 Remove high pressure pump

REP-TAT-P-1353-01 Remove high pressure pump

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Working on fuel system. 
Risk of fire! Danger of explosion! 
  • When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.
  • Tightly seal off open lines and connections; collect any leakage fuel directly at the point of exit.
  • No fire, sparks, open flames or smoking.
NOTE: RISK OF DAMAGE 
Damage to the ignition coil. 
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil. 
  • When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
  • Do not oil or grease the silicone tube of the spark plug socket. The silicone tube is coated with talcum powder to reduce the pulling forces.
scientia non olet · About LEMON Manuals