REP-TAT-P-1722-01 Remove transmission oil cooler
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work:
- Refer to REMOVING RIGHT LUGGAGE COMPARTMENT TRIM PANEL
- Disconnect BATTERY EARTH LEAD
- Refer to REMOVING THE ACOUSTIC COVER
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Refer to REMOVING REAR UNDERBODY PROTECTION
- Refer to REMOVING THE SUPPORT FOR THE UNDERBODY PROTECTION
- Refer to REMOVING THE PROTECTIVE PLATE FOR THE FUEL LINES
- Refer to DRAINING THE COOLANT FROM THE HIGH-TEMPERATURE COOLING SYSTEM
- Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM
- Remove cover for the DME control unit
- Disconnect the connector from the DME control unit and from the power distribution module (PDM)
- Refer to REMOVING THE DME CONTROL UNIT
- Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
- Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
- Refer to REMOVING THE INTAKE PLENUM
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.