23 11 Housing with lid
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
2311 HOUSING WITH LID - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Instructions | Torque Specification | |
|---|---|---|---|---|
| 1AZ Transmission housing, rear section/front section | H/I-transmission | 22 Nm | ||
| 2AZ Lid guide tube/transmission housing | H/I/K-gearbox | M8 x 22 | 18 Nm | |
| H/I/K-gearbox | M8 x 30 | 25 Nm | ||
| H/I/K-gearbox | M6 | 10 Nm | ||
| 3AZ Bearing cap/sealing flange | H/I-transmission | 10.5 Nm | ||
| 4AZ Reverse gear wheel axle to intermediate case | H/I-transmission | 49 Nm | ||
| 5AZ Holding plate for reverse gear wheel axle to intermediate case | H/I-transmission | 25 Nm | ||
| 6AZ Transmission closing plate | H/I-transmission | M6 | 8 Nm | |
| 7AZ Grounding cable to transmission | M8 | 19 Nm | ||
| 8AZ Ground cable to body | M8 | 19 Nm |
2311 HOUSING WITH LID - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Instructions | Torque Specification | |
|---|---|---|---|---|
| 16AZ Support plate on the intermediate housing | 265/Sport | M6 | 9 Nm | |
| 17AZ Support plate for the bearings on the housing | S5D 310Z/S5D 320Z/S5D 200G/S5D 250G | M6 | 10 Nm | |
| 18AZ Support plate on the housing | S5D 320Z SMG | M6 | 5.5 Nm |