26 12 011 Replacing grooved ball bearing in propeller shaft center bearing
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 23 1 160
- 33 3 202
- 33 3 203
- 00 7 500
- 23 2 430
Necessary preliminary tasks:
- Replace PROPELLER SHAFT CENTER BEARING .
Removal:
Install special tool 00 7 500 between deep groove ball bearing (1) and propeller shaft (2).
Using a hydraulic press, force deep groove ball bearing (1) off propeller shaft (2).
Installation:
Use special tool 23 2 430 to press new deep groove ball bearing (1) on to propeller shaft (2).
Required follow-up work:
- Install PROPELLER SHAFT CENTER BEARING .