26 11 020 Replacing center mount gaiter

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove PROPELLER SHAFT .

Removal:

NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

G11107083

Courtesy of BMW OF NORTH AMERICA, INC.

Pull apart propeller shaft.

G11107084

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

G11107085

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Apply an even coating of grease to longitudinal splines on shaft.

Slide gaiter (1) into groove (2) and make sure it is fitted securely.

Grease: refer to PROPELLER SHAFT - OPERATING FLUIDS .

G11107085

Courtesy of BMW OF NORTH AMERICA, INC.

Parts : If necessary, insert new clamping ring (1) into front propeller shaft (2).

G11107087

Courtesy of BMW OF NORTH AMERICA, INC.

Observe markings and force front propeller shaft (3) onto longitudinal splines of rear propeller shaft (4) (markings must be flush).

Slide gaiter (1) onto groove (2).

G11107083

Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work:

Install PROPELLER SHAFT .