23 12 092 Replacing radial shaft seal for gearshift shaft (GS6-45BZ/DZ)

Special tools required: 

• 2 219 637
• 23 0 220

Attention! 

After completion of repair work, check TRANSMISSION OIL LEVEL .

Use only the approved TRANSMISSION OIL .

Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks: 

• Shift transmission into 2nd gear.
• Partially release PROPELLER SHAFT .
  • Disconnect propeller shaft at transmission.
  • Release center mount.
  • Tie up propeller shaft to underbody.
    NOTE: Bending the propeller shaft by an excessive angle can cause premature damage to the joint/propeller shaft!

Removal: 

Undo screw (1) and slightly lower transmission.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and remove bearing journal in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off retaining clip (1) and remove gearshift rod.

Courtesy of BMW OF NORTH AMERICA, INC.

Lever circlamp (3) out of groove with a small screwdriver.

Slide circlamp (3) towards rear.

Drive out the cylindrical pin (1) and remove the gearshift rod joint (2) from gearshift shaft.

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 2 219 637 until it is firmly connected with radial shaft seal (1).

Pull out radial shaft seal with special tool 2 219 637.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Coat sealing lips of radial shaft seal and gearshift shaft with transmission oil.

Drive in radial shaft seal with special tool 23 0 220.

Courtesy of BMW OF NORTH AMERICA, INC.

Slide gearshift rod joint (2) onto gearshift shaft and drive in cylindrical pin (1).

Use circlip (3) to secure cylindrical pin (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Install bearing journals (1) and lock in direction of arrow.

Grease bearing journal.

Grease, refer to BMW SERVICE OPERATING FLUIDS. 

Courtesy of BMW OF NORTH AMERICA, INC.

Install gearshift rod and insert retaining clip (1) till it is engaged.

Grease gearshift rod pin.

Grease, refer to BMW SERVICE OPERATING FLUIDS .

Courtesy of BMW OF NORTH AMERICA, INC.

Insert screw (1) and tighten.

Tightening torque: 10 Nm

Courtesy of BMW OF NORTH AMERICA, INC.