REP-TAT-P-1251-02 Install the wiring harness section for sensor system 2

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Overview: Wiring harness section for sensor system 2

Courtesy of BMW OF NORTH AMERICA, INC.

Wiring harness section for sensor system 2

Prerequisite

Route the wiring harness section (1) and fasten it with the clamps.
Connect and audibly lock the connector of the DME control unit.
Connect and audibly lock the connector of the integrated supply module (PDM).
Connect and audibly lock the connector of the Valvetronic servomotor.
Connect and audibly lock the connector of the rail pressure sensor.
Connect and audibly lock the connector of the hot film air mass meter.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect and audibly lock the connector of the camshaft sensor of the intake camshaft.
Connect and audibly lock the connector of the camshaft sensor of the exhaust camshaft.
Connect and audibly lock the connector of the front oxygen sensor.
Connect and audibly lock the connector of the monitoring oxygen sensor.
Connect and audibly lock the connector on the high pressure pump.
Connect and audibly lock the connector of the heating element on the vent hose.
Connect and audibly lock the connector of the electrical controller drive for the wastegate valve.
Connect and audibly lock the connector of the VANOS solenoid actuator.
Mount the cable channel on the intake plenum.
Tighten down screws (3).
TIGHTENING TORQUES SPECIFICATION

Cable duct to intake plenum 4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.
Mount the tank ventilation line (2) on the intake plenum.

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Tank vent line to intake plenum
Oval-head screw	Tightening torque	3 Nm