REP-TAT-P-1161-02 Installing the intake plenum
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Replace gaskets (1).
Parts : Seals
NOTE: TECHNICAL INFORMATION
Additional coolant can leakage. Make sure that no coolant enters the intake port of the cylinder head. - Position the intake plenum.
- Tighten screws in the order (1) to (7).TIGHTENING TORQUES SPECIFICATION
Intake plenum to cylinder head Observe tightening sequence. Joining torque 5 Nm Tightening torque 10 Nm - Tighten down screws (8).TIGHTENING TORQUES SPECIFICATION
Intake plenum to rear/front support BM6 x 25 10 Nm NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly. - Lock the closure (2) and connect the coolant return line.
- Lock the closure (1) and connect the coolant feed line.
- Clip the wiring harness into the clamp (3).
- Clip in wiring harness in marked areas.
- Connect the connector (1) to the boost pressure sensor.NOTE: TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly. - Lock closure (2) and connect to the coolant pipe.
- Attach the tank vent line (1) in the signaled area.
- Clip in cable (6) in marked areas.
- Position the engine wiring harness and tighten with the screws (5).TIGHTENING TORQUES SPECIFICATION
Wiring harness to intake plenum 5 Nm - Position tank vent line (4).
- Tighten the screw (3) and clip in the tank vent line (4) in the marked area.TIGHTENING TORQUES SPECIFICATION
Tank vent line to intake plenum TS5 x 16 5 Nm - Connect the engine ventilation line (2) to the intake plenum.
- Clip in the tank vent line (1) in the marked area.