REP-TAT-P-1251-02 Install the wiring harness section for the injectors
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Connect all connectors (1) from back to front to the DME control unit and audibly lock them in place.
- Insert the wiring harness (2) and lock it audibly with the clamps (3).
- Connect all connectors (1) to the ignition coils and audibly lock them in place.
- Connect all connectors (2) to the injectors. They must lock audibly.
- Tighten nuts (1).TIGHTENING TORQUES SPECIFICATION
Ground cable to rail M6 tightening torque 5 Nm