LEMON Manuals
: Even more car manuals for everyone
Home
>>
BMW
>>
2018
>>
340i xDrive Automatic Trans
>>
Repair and Diagnosis
>>
External Pages
>>
Different car
>>
Section 231 (Engine Electrical System - Repair (F30, 6-CYL RWD))
>>
12 14 Engine Control Module And Sensors
>>
12 14 521 Replace crankshaft sensor (after vehicle diagnosis)
>>
REP-TAT-P-1214-02 Installing the crankshaft sensor
REP-TAT-P-1214-02 Installing the crankshaft sensor
WARNING:
This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Feed in and install the crankshaft sensor (3).
Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
Crankshaft sensor to crankcase
TS5x20
tightening torque
4.6 Nm
Courtesy of BMW OF NORTH AMERICA, INC.
Connect connectors (1) and lock.
The connector (1) must engage audibly.