00 02 000 Raising vehicle with trolley jack
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
Observe the following trolley-jack-related notes:
- Only trolley jacks sold or approved by BMW, with a rubber plate on their mounting, may be used!
- Trolley jacks must be regularly serviced and always checked for functional reliability before they are used!
- Check the rubber plate on the trolley jack prior to each use, replacing if necessary.
WARNING:
The vehicle may be raised with a trolley jack only
at the following mounting point!
- Car jacking pointNOTE: When raising, the underbody panelling is pressed against the front axle support.
- Side car jacking points
- Rear axle final drive
NOTE:
It is not permitted to raise the vehicle at the rear differential cover!
Risk of damage!
Jacking point (1) must be present!
Align the rubber plate on the trolley jack to the jacking point (1) in such a way that there is no contact to adjacent components and that they are therefore not damaged.