REP-TAT-P-3221-01-F30 Removing the track rod end

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Component damage caused by striking tools .
Brute force can result in component damage .

Only use those tools intended for the work.

NOTE: Description is for left component only. Procedure on the right side is identical.

Loosen the nut (1), if necessary, counter-hold the Torx socket.
Remove the track rod end (2) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.