32 00 620 Adjusting rear axle

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For vehicles with Adaptive Cruise Control (ACC):

After an adjustment of the rear axle, which alters the driving axis, check setting of ACC sensor and adjust if necessary (refer to ADJUSTING THE ACC SENSOR ).

Necessary preliminary work:

Remove left and right COVERS on the camber control arm

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (1) and eccentric bolt (2) and tighten to 5 Nm.

Turn eccentric bolt (2) to adjust camber to setpoint value.

Tighten nut (1).

Tightening torque 33 32 9AZ .

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and apply 5 Nm.

Turn eccentric bolt (1) to adjust toe to setpoint value.

Tighten nut (2).

Tightening torque 33 32 7AZ .

Courtesy of BMW OF NORTH AMERICA, INC.