37 14 566 Remove and install/replace the VDM control unit

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

64 1 020

IMPORTANT: Read and comply with NOTES ON ESD PROTECTION (ELECTROSTATIC DISCHARGE) .

Necessary preliminary tasks:

Remove luggage compartment floor trim panels (F31 only)

F30/F32/F33/F35:

Remove flap (1) on rear right in luggage compartment trim panel.

Courtesy of BMW OF NORTH AMERICA, INC.

F31:

Lift out expanding rivets (1) and trim (2) for adaptive securing system with special tool 64 1 020.

Remove luggage compartment trim panel in direction of arrow.

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Unlock connector (2) and remove.

Remove control unit.

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Carry out PROGRAMMING/ENCODING
Start up the VDM with the aid of the diagnosis system
Carry out RIDE HEIGHT ADJUSTMENT