37 14 511 Replacing font ride height sensor

WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque, refer to: 37 14 4AZ .

Detach jointed rod (2).

Disconnect plug connection (3).

Release screws (4).

Tightening torque, refer to: 37 14 2AZ .

Remove ride height sensor to front.

Installation note:

Replace nut (1).

Sensor lever points in direction of travel starting from ride height sensor.

After installation:

Check headlight adjustment, correct if necessary.