26 11 090 Removing and installing/replacing centering for propeller shaft in three-hole flange
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 5 500
- 11 1 310
- 11 2 030
Necessary preliminary tasks:
- Remove the PROPELLER SHAFT.
Completely fill centering bore hole (1) with viscous grease.
Drive special tool 11 1 310 with a plastic hammer into centering bore hole.
The centering bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.
If necessary, top up grease repeatedly.
NOTE:
To drive out the bearing, you can also fill the centering bore hole with water instead of grease.
Installation note:
Grease or water must be removed from the bearing bore.
Drive in centering mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).
IMPORTANT:
Plastic centering mount must not be greased.
Installation note:
Observe protrusion A = 4+2 mm of centering (1).