24 40 Torque converter
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
24 40 TORQUE CONVERTER - TIGHTENING TORQUES SPECIFICATIONS
| Type | Thread | Instructions | Torque Specification | |
|---|---|---|---|---|
| 1AZ Torque converter to flywheel | GA6HP19Z/GA6HP26Z/GA6HP32Z/GA8HP45Z/GA8HP50Z/GA8HP70Z GA8HP75Z | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
56 Nm |
| GA6HP26Z/GA8HP75Z/GA8HP90Z/(AWD) | M10 10.9 | Observe tightening sequence. Refer to the applicable repair instructions! Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | |
| F30/F31/F32/F33/F35 N20 GA8HP45Z | M10 10.9 | Replace converter screws. (Remove adhesive residue from thread, if applicable) |
60 Nm | |
| 2AZ Electrical machine to flywheel | GA8P70H | M10 | Replace hexagon nuts. (Remove adhesive residue from thread, if applicable) |
56 Nm |