17 00 011 Draining and topping up low-temperature coolant (B48)

Special tools required: 

• 00 2 030

Attention! 

Lifetime coolant filling: 

Never reuse used coolant!

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.

In the case of other removal work involving the draining of part quantities of coolant, replace these quantities which have been drained with new coolant.

Installation note: 

Use only recommended coolant. Refer to: RADIATOR - OPERATING FLUIDS

Observe mixture ratio. Refer to specifications in: RADIATOR - OPERATING FLUIDS

Protective measures/rules of conduct: 

• Wear safety goggles
• Wear protective gloves
• Observe national/country-specific regulations

Attention! 

For contamination of the cooling system (e.g. by engine oil), the cooling system must be rinsed with water until all contamination is removed!

Courtesy of BMW OF NORTH AMERICA, INC.

Attention! 

Risk of skidding due to coolant on the floor.

Danger of injury! 

Catch and dispose of drained coolant in drip tray (1) and if necessary special tool 00 2 030 (universal hydraulic lifting equipment).

Recycling: 

Observe country-specific waste disposal regulations.

Necessary preliminary tasks: 

• Remove the FRONT UNDERBODY PROTECTION.
• Remove stiffening plate (F23, F33) 

Removal: 

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen the sealing cap (1) on the low-temperature coolant expansion tank.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and loosen clamp along the arrows.

Loosen screws (1).

Feed out cover (2) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock coolant line (1) and release.

Drain, catch and dispose of coolant.

Installation: 

Courtesy of BMW OF NORTH AMERICA, INC.

Connect coolant line (1) and lock.

The coolant line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install the cover (2).

Connect and lock the clamps along the arrows.

Tighten down screws (1).

Tightening torque, refer to: 51 75 2AZ.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screws (1).

Tightening torque, refer to: 51 75 2AZ.

Adding coolant: 

Use only recommended coolant. Refer to: RADIATOR - OPERATING FLUIDS

Observe mixture ratio. Refer to specifications in: RADIATOR - OPERATING FLUIDS

Observe capacities. Refer to capacities in RADIATOR - OPERATING FLUIDS

Fill and vent COOLING SYSTEM .

Observe bleeding instructions without fail. 

Required reworking: 

• Install the FRONT UNDERBODY PROTECTION.
• Install stiffening plate. (F23, F33)