Intake System: Notes
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUES SPECIFICATIONS
| Holder for intake system to cylinder head/crankcase | ||
| M6 | Tightening torque | 10 Nm |
| Holder for wiring harness to intake system | ||
| screw | Tightening torque | 5 Nm |
| Intake plenum holder on engine | ||
| BM6x 16 | Tightening torque | 10 Nm |
| Intake plenum to cylinder head | ||
| M6 | Tightening torque | 10 Nm |
| Intake system to holder front/rear | ||
| Tightening torque | 8 Nm | |
| Tank vent line to intake system | ||
| Tightening torque | 5 Nm | |