Cylinder Head With Lid: Notes
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUES SPECIFICATIONS
| Bearing journal to cylinder head | ||
| Replace the bearing journal! | Tightening torque | 20 Nm |
| Cylinder head to crankcase | ||
| M11x1.5x188 11.9 | 1. Joining torque | 30 Nm |
| Fit new cylinder head bolts. | 2. Angle of rotation | 90° |
| 3. Angle of rotation | 180° | |
| M11x1.5x188 13.9 | 1. Joining torque | 30 Nm |
| Fit new cylinder head bolts. | 2. Joining torque | 50 Nm |
| 3. Angle of rotation | 180° | |
| 4. Angle of rotation | 180° | |
| Cylinder head to special tool 2 361 215 | ||
| Tightening torque | 35 Nm | |
| Flange to assembly jig | ||
| M14X30 | Tightening torque | 135 Nm |
| Front lifting eye on the cylinder head | ||
| M8 x 22 | Tightening torque | 19 Nm |
| Sliding rail to cylinder head | ||
| M6x16 | Tightening torque | 8 Nm |
| Trim strip at the cylinder head | ||
| M7 | 1. Joining torque | 10 Nm |
| 2. Joining torque | 16 Nm | |
| 3. Tightening torque | 18 Nm | |
| Venting connector/special tool to cylinder head | ||
| M10 | Tightening torque | 18 Nm |