Charger With Control: Notes
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUES SPECIFICATIONS
| Electrical controller drive to exhaust turbocharger | ||
| screw | Tightening torque | 2.5±0.5 Nm |
| Heat shield to cylinder head | ||
| M8x 12 | Tightening torque | 19 Nm |
| Heat shield to trim strip | ||
| M6x 12 | Tightening torque | 8 Nm |
| Wastegate valve controller control rod | ||
| Always use a second open-end wrench (for counter support) to tighten the lock nut! | 6±0.3 Nm | |