31 35 005 Removing and installing anti-roll bar link for left or right anti-roll bar
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Risk of damage!
- Avoid bending the head of the anti-roll bar during assembly!
- An impact screwdriver must not be used!
Necessary preliminary tasks:
- Remove the FRONT WHEEL.
IMPORTANT:
It is important to counterhold Torx socket when loosening push rod screw connection (1).
Unscrew nuts (1).
Tightening torque, refer to: 31 35 2AZ .
Remove anti-roll bar link (2).
Installation note:
Replace self-locking nuts.