31 00 Mobile table lift
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Injury hazard!
Before beginning work, position table lift with the lower frame securely on the floor.
Area around mechanism below platform is hazardous.
Follow the operating instructions from the equipment manufacturer.
Before beginning work, position table lift with the lower frame securely on the floor.
Area around mechanism below platform is hazardous.
- Do not reach into or step into the hazardous area.
- Note permissible bearing capacity of table lift.
- Mount load centrally (danger of tipping) and secure against shifting.
Follow the operating instructions from the equipment manufacturer.
The mobile table lift is used for collision repairs and when removing large engines.
Adaptations for mounting front axle with engine and transmission.
| No. 10 | For mounting swivel bearing with brake disc |
| No. 20 | Mounting element for adjustable stand |
| No. 30 | Adjustable stand |
| No. 40 | Distance pin 40 x 160 mm |
| No. 50 | Distance pin 40 x 110 mm |
| No. 60 | Distance pin 40 x 60 mm |
| No. 70 | Stand with U-profile |
| No. 80 | Plate stand dia. =100 mm |
Release star knob screw on working plate (B) of table lift; the working surface (B) can be extended by approx. 310 mm.
Release all push-pull clamps and the working plates can be shifted by approx. 20 mm.
Working plate (A and B) can be raised and lowered by 3° on the long side and by 5° on the transverse side.
Working plate (A and B) is subdivided by a coordinate system and a possible installation position is recommended in the respective repair manual.
IMPORTANT:
Follow the operating instructions from the equipment manufacturer.