22 32 050 Replacing cross member for transmission mounting, all-wheel drive
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove the REAR UNDERBODY PROTECTION.
- Release the heat shield.
- Support transmission with lifter.
- If necessary, release holder for exhaust system on transmission cross-member.
Release screws.
Tightening torque, refer to: 22 32 3AZ .
Slacken nut (1).
Tightening torque, refer to: 22 32 6AZ .
Pull out screw (2).
Move transmission cross member (3) in direction of arrow and remove screw (2).
Remove transmission cross-member.