22 11 011 Replacing left engine mount

WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Secure the ENGINE IN INSTALLATION POSITION .
Remove the REINFORCEMENT PLATE .

Removal:

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (1).

Remove engine mount (2).

Installation:

Courtesy of BMW OF NORTH AMERICA, INC.

Rubber part (1) of engine mount must point to center of vehicle.

Install engine mount (2).

Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque, refer to: 22 11 1AZ .

Required follow-up work:

Remove the FASTENING .
Install the REINFORCEMENT PLATE .