LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> 340i xDrive Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Steering And Wheel Alignment - Repair (F30, 4-CYL AWD)) >> 32 34 Driver's Airbag >> 32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)

32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)

WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Observe the following instructions to avoid any risk of injury by the airbag unit.
NOTE: Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT: Steering wheel must be REPLACED  if airbag unit has been triggered!
Follow PROCEDURE AFTER AIRBAG DEPLOYMENT .

Necessary preliminary tasks: 

Insert Torx screwdriver T20 (1) vertically into the concealed opening until limit position (2) can be felt.

Pull Torx screwdriver (1) approx. 2-3 mm out of opening. Press screwdriver handle carefully towards middle of steering wheel and simultaneously slide into opening in order to position the Torx screwdriver behind retaining spring bracket (refer to graphic below).

IMPORTANT: Press Torx screwdriver carefully towards the middle of steering wheel and slide it in again! Pushing the Torx screwdriver too much further in the direction of steering wheel center will lead to damage of the steering wheel trim/the steering wheel.
G10095560Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining spring bracket (1) of airbag unit inwards and simultaneously pull airbag unit upwards until it unlocks.

Repeat procedure on other side.

Installation note: 

Carefully push airbag unit in direction of steering column shaft into steering wheel with uniform pressing force until airbag engages noticeably and audibly.

G10095561Courtesy of BMW OF NORTH AMERICA, INC.
WARNING: Danger of injury!
The airbag unit may only be set down with the airbag itself facing up  .

Tilt airbag unit forwards.

Disconnect plug connections (1) and remove airbag unit.

Installation note: 

Make sure electrical leads are correctly positioned.

G10095557Courtesy of BMW OF NORTH AMERICA, INC.