32 31 102 Replacing steering shaft collar
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL MECHANISM
- Remove AIRBAG MODULE FOR DRIVER'S KNEE PROTECTION
- Unclip air duct in footwell.
- Remove bottom STEERING SHAFT in engine compartment.
Pull locking pin (1) off of steering shaft collar.
Press in latch mechanisms (2) from engine compartment and press steering shaft collar in passenger compartment.
- Remove STEERING COLUMN with steering shaft collar.
Installation note:
Mount STEERING COLUMN with steering shaft collar from passenger compartment.
Screw steering column on body.
Insert steering shaft collar into the recesses in the bulkhead and press in until the latch mechanisms engage audibly and palpably.
Check latch mechanisms from engine compartment for tight fit and mount locking pin.