REP-TAT-P-3221-26-F30 Remounting the track rod end
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Perform wheel alignment after installation.
Description is for left component only. Procedure on the right side is identical.
- Determine dimension A to simplify subsequent setting of front axle.
- Slacken screw 1 .
- Unscrew the track rod end, if applicable, counter support the track rod with the open-end spanner.
- Screw on the track rod end to this dimension A .
- Tighten down screw 1 .
Tightening torques
| Track rod end to track rod | |
|---|---|
| 32Nm | |