REP-TAT-P-3221-02-F30 Installing track rod end
WARNING: This page is about a different car, the 2018 BMW 330i xDrive and 2017 BMW 330i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Description is for left component only. Procedure on the right side is identical.
Check
- Check the gaiter and the spring circlip for damage.
Result
Component is cracked or porous.
Measure
- Replace component.
Parts: Component
Keep the connection of the tie rod end to the swivel bearing clean and free from oil and grease.
- Insert track rod end 2 into the swivel bearing.
Self-locking nuts must be replaced and must not be reused.
- Replace nut 1
.
Parts: Nut
- Tighten the nut 1 , if necessary, counter support the Torx socket.
Tightening torques
| Track rod end to swivel bearing | |
|---|---|
| M14 Replace self-locking nut. |
175Nm |