REP-TAT-P-1231-02 Installing the alternator
- Slightly push back the threaded support sleeve (2) in the direction of the arrow to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support sleeve (2).
- Press back the threaded support sleeve (2) using the bolt (1).
- Once again unscrew the screw (1) from the threaded support sleeve (2).
- Insert and install the alternator (2).
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATIONS
Alternator to component carrier M10x75 Tightening torque 38 Nm M10x125 Tightening torque 38 Nm - Tighten nut (1).TIGHTENING TORQUES SPECIFICATIONS
Positive battery cable to the alternator M8 Tightening torque 19 Nm - Connect and lock the connector (2).
The connector (2) must engage audibly.