REP-TAT-P-1142-02 Installing the oil-to-coolant heat exchanger

NOTE: RISK OF DAMAGE 
Damage to the surface. 
The use of metal-cutting tools (e.g. emery cloth) to clean the surfaces can damage them and lead to leaks or engine damage. 

• Do not use any metal-cutting tools.

• Clean sealing surface (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace gaskets (1), (2), (3) and (4).

  Parts:  Seals

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the oil-to-coolant heat exchanger on the fullflow oil filter.
• Tighten the screws (1), (2), (3), (4), (5) and (6).

TIGHTEN TORQUES SPECIFICATIONS

Oil-to-water heat exchanger to full-flow oil filter
M6	Tightening torque	10 Nm

Fig 1: Oil-To-Coolant Heat Exchanger Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.