REP-TAT-P-1711-02 Install fan cowl
Prerequisite
Ignition is switched off.
- Feed in and install the fan cowl (5) in the direction of the arrow.
The lock (4) must audibly engage.
- Tighten down screw (3).TIGHTENING TORQUES SPECIFICATION
Fan cowl on radiator D6X20 6 Nm - Secure clamps (2).
- Connect and lock the connector (1).
The connector (1) must engage audibly.
Follow-up work:
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING