REP-TAT-P-1231-02 Installing the alternator

• Slightly push back the threaded support sleeve (2) in the direction of the arrow to facilitate the installation of the alternator.
• Screw the screw (1) into the threaded support sleeve (2).
• Press back the threaded support sleeve (2) using the bolt (1).
• Once again unscrew the screw (1) from the threaded support sleeve (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the alternator (2).
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Alternator to component carrier
  M10x75	Tightening torque	38 Nm
  M10x125	Tightening torque	38 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Positive battery cable to the alternator
  M8	Tightening torque	19 Nm

• Connect and lock the connector (2).

  The connector (2) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.