REP-TAT-P-1134-02 Install all valves
NOTE:
RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.
- Adhere to the utmost cleanliness.
- Protect components from contamination e.g. by covering.
- Close off line connections with seal plugs.
- Carefully
push the valve (1) into the cylinder head.
- Equipment specification B38
- Prepare the special tools 0 494 371 (11 9 006), 0 494 372 (11 9 007) and 0 494 373 (11 9 008) as
shown.
- Equipment specification B46/B48
- Prepare the special tools 0 494 371 (11 9 006), 0 494 372 (11 9 007) and 0 494 373 (11 9 008) as
shown.
- Equipment specification B58
- Prepare plastic shaped parts (1) with the shaped parts (2) and aluminum frame insert (3).
- Equipment specification B38
- The special tools 0 494 373 (11 9 008)
must be set up accordingly in the next operation.
- Equipment specification B46/B48
- The special tools 0 494 373 (11 9 008) must be set up accordingly in the next operation.
NOTE:
TECHNICAL INFORMATION
The figure shows the engine B58.
The figure shows the engine B58.
- Position special tools 0 494 371 (11 9 006), 0 494 372 (11 9 007) and 0 494 373 (11 9 008) in the
center on the cylinder head in the direction of the arrow.
- Turn round special tool 0 494 371 (11 9 006) and insert as shown.
- Lock special tool 0 494 370 (11 9 005)
in arrow direction.
- Shift and lock special tool 0 494 370 (11 9 005)
in the direction of the arrow over the edges of special tool 0 494 371 (11 9 006)
.
- Turn the device (2) on the crank (1) 180° in arrow direction
.