REP-TAT-P-1131-25 When replacing intake camshaft: Remount camshaft sensor wheel

• Rotate intake camshaft, if necessary in the position shown up to the recess (2).
• Loosen screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide out and remove the camshaft sensor wheel (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the camshaft sensor wheel (1) into the new intake camshaft.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Rotate intake camshaft, if necessary in the position shown.

NOTE: The recess (2) must point up.

• Position camshaft sensor wheel and tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Camshaft sensor wheel to intake camshaft
M4 x35	4.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.