Replacing cross member for transmission mounting (B48 hybrid drive)
WARNING:
High-voltage system - danger to life!
WARNING:
The following points must be strictly observed prior to starting work:
- Observe SAFETY INFORMATION for handling hybrid cars.
Necessary preliminary tasks:
- Remove rear UNDERBODY PROTECTION .
- Support transmission with lifter.
Removal:
Loosen screws (1).
Unscrew nuts (2).
Remove cross member.
Installation:
Install cross member.
Tighten down nuts (2).
Tightening torque 22 32 4AZ .
Tighten down screws (1).
Tightening torque 22 32 3AZ .
Required follow-up work:
- Install heat shield.
- Install the rear UNDERBODY PROTECTION .