Replacing two rubber mounts (rear) for rear axle support

Special tools required: 

• 33 4 140 
• 33 0 012 
• 33 4 149 
• 2 241 760 
• 2 208 576
• 2 155 744 
• 2 208 574 
• 2 241 779 
• 2 241 780 

Necessary preliminary work: 

• Lower REAR AXLE SUPPORT .

Withdrawing rubber mount: 

Complete the special tool 33 4 140  in connection with 33 0 012  and 33 4 149  as shown.

Courtesy of BMW OF NORTH AMERICA, INC.

Align notch (1) on special tool 2 241 760  with notch (2) on the rear axle support.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out the rubber mount by using the special tools 2 241 760  , 33 4 140  , 2 208 576  , 2 155 744  and 2 208 574  from the rear axle support.

Make sure special tool 33 4 140  is correctly supported on rear axle support bush.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing rubber mount: 

Notch (1) and arrow (2) of the rubber mount must point in the direction of travel.

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in the rubber mount (1) with the special tools 2 241 779  , 2 241 780  , 2 155 744  , 2 208 574  and 2 208 576 up to the limit position.

Courtesy of BMW OF NORTH AMERICA, INC.