Replacing two rubber mounts (front) for rear axle support

Special tools required: 

• 33 4 140 
• 33 0 012 
• 33 4 149 
• 0 496 887 
• 2 208 576
• 2 155 744 
• 2 208 574 
• 33 4 432
• 33 4 433

Necessary preliminary tasks: 

• Lower REAR AXLE SUPPORT .

Withdrawing rubber mount: 

Complete special tool 33 4 140  using 33 0 012  and 33 4 149  , as shown.

Courtesy of BMW OF NORTH AMERICA, INC.

Align notch (1) on special tool 0 496 887  with notch (2) on the rear axle support.

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out rubber mounts using special tools 0 496 887  , 33 4 140  , 2 208 576, 2 155 744  and 2 208 574  pull out of the rear axle support.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing rubber mount: 

Notch (1) and arrow (2) of the rubber mount must point in the direction of travel.

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in rubber mount (1) with special tools 33 4 432, 33 4 433, 2 155 744, 2 208 574  and 2 208 576 to limit position.

Courtesy of BMW OF NORTH AMERICA, INC.