Replacing left or right trailing arm
WARNING:
High-voltage system - danger to life
- Observe SAFETY INFORMATION for handling electric vehicles.
IMPORTANT:
- The trailing arm must be installed with the opening (U-section) facing downward!
Unscrew nuts (1).
Tightening torque 33 32 1AZ .
Move screw toward the rear.
Installation note:
Note direction of insertion of bolts.
Replace nut.
Tighten down screw connection in NORMAL POSITION .
Slacken nut (2).
Tightening torque 33 32 2AZ .
Move screws toward the rear.
Remove trailing arm (3) downward.
Installation note:
The trailing arm must be installed with the opening (U-section) facing downward!
Note direction of insertion of screw.
Replace nut.
Tighten down screw connection in NORMAL POSITION .