Removing and installing/replacing left or right camber arm

Necessary preliminary tasks: 

• Remove COIL SPRING, REAR .
• Remove CAMBER ARM COVER .

Only on left side at ride-height sensor: 

Release screw (1) and remove holder (2) with jointed rod. Tightening torque 37 14 3AZ .

Installation note: 

Replace screw.

Courtesy of BMW OF NORTH AMERICA, INC.

Secure camber arm against falling off.

Mark installation position of eccentric adjustment washer to rear axle support to simplify subsequent adjustment of rear axle.

Release nut (1) and remove eccentric bolt.

Tightening torque 33 32 9AZ .

Installation note: 

Note insertion direction of eccentric screw.

Replace nut.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw connection in NORMAL POSITION .

Release nut (2) and remove screw.

Tightening torque 33 32 10AZ .

Installation note: 

Note direction of insertion of screw.

Replace nut.

Release nut (3) and remove screw.

Tightening torque 33 52 3AZ .

Installation note: 

Note direction of insertion of bolts.

Replace screw and nut.

Tighten down screw connection in normal position.

After installation: 

• Carry out Wheel Alignment Procedure. Refer to KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH VEHICLE LOAD UP TO DESIGN POSITION or KINEMATICS DIAGNOSIS SYSTEM WHEEL ALIGNMENT WITH RIDE HEIGHT MEASUREMENT WITHOUT LOADING THE VEHICLE .